The Perfect Addition to Any Vehicle Biosecurity Program.
(Model Z-010) The fastest and easiest way to clean surfaces is the Tornador® Classic Cleaning Tool. The perfect addition to any vehicle biosecurity program, this tool works with your air compressor to blast cleaning solution into crevices you can't reach by hand. Clean carpet, plastics and upholstery inside the vehicle and wheels, convertible tops and body seams on the exterior.
Cleans in tough-to-reach spots like between seats and in seams. Because it releases so little liquid, surfaces dry quickly. No need to scrub, it does all the work for you.
The oscillating tip creates a tornado cleaning action to clean hard and soft surfaces. Dirt and grime are immediately released from fabrics, carpet and solid surfaces. It releases a fine mist of cleaning solution that does not over-saturate surfaces. You will actually see the liquid turning dirty as grime is released from the surface. All you need to do next is turn the dial to shut off the water and use compressed air to dry the area.
Must be used with an air compressor capable of producing a constant air pressure of at least 60 PSI. Do not exceed 110 PSI to protect your Tornador® from unnecessary wear. Use the green valve to control the amount of liquid released.
To clean any surface, dilute the cleaning solution per label directions. Turn the liquid valve straight up and use and overlapping motion as you pass it over the surface. If necessary, allow the liquid to sit for 10-15 seconds. Then turn the liquid valve off and use compressed air to dry the area.
Includes: Tornador® Classic Cleaning Tool with a 32 oz. jar and an extra cap for the jar. Foaming gun available upon request (sold separately).
- Weight: 1.34 lbs
- Dimensions: 12.6" L x 5" W x 9.15" H
- Free Speed RPM: 3,600
- Air Consumption: 1/min = 120
- Liquid Consumption: 1/hr = 3.6
- Sound Pressure DBA: 101.1
- Air Inlet: 1/4"
- Air Pressure: 6.2 BAR @ 90 PSI
Note: After every use, place nozzle 2-3" into a bucket of soapy water while depressing the trigger once or twice to quickly remove dirt build-up in the cone. This will prevent premature wear.
|Manufacturer Part Number||Z-010|